Cold-Formed Steel: LCB Column Bases

www.strongtie.com

LCB Column Bases

LCB uses screws, which allows for fast installation, reduced reveal and high capacity, while maintaining the net section of the column.

Finish: LCB - galvanized.

Material: See table.

Installation:

Use all specified fasteners. See General Notes.
For full loads, minimum side cover required is 2" for LCB.
Install all models with bottom of base plate flush with concrete.
Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non top-supported installations (such as fences or unbraced carports).

Options:

roll over images below to see larger image


LCB44 (LCB46, LCB66 similar) Installation for cold-formed steel built-up column. Note: The engineer of record is responsible for design of column member.

Tabulated loads shown at (100) do not include steel stress increase. Tabulated loads shown at (133) include a 1/3 stress increase on the steel. Refer to Steel Stress Increase for additional information.
Sizes indicate nominal dimensions.
Designer is responsible for concrete design.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
LCB	See specific model numbers for code listings.
LCB44						ER-5708
LCB46						ER-5708
LCB66						ER-5708

topDrawings: To download drawings, right-click or Ctrl-click on the link, then choose "Save Target As..."

Download the Simpson AutoCad Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
LCB	None for this model	CB or LCB: DWG \| DXF LCB: DWG \| DXF
LCB44	LCB44: DWG \| DXF LCB44 front view: DWG \| DXF LCB44 left view: DWG \| DXF LCB44 right view: DWG \| DXF	None for this model
LCB46	None for this model	None for this model
LCB66	LCB66: DWG \| DXF LCB66 front view: DWG \| DXF LCB66 left view: DWG \| DXF LCB66 right view: DWG \| DXF	None for this model