www.strongtie.com


Nailon Pin Drive Anchors

Nylon and Zinc Nailon™ anchors are low cost anchors for light-duty applications under static loads.

GALLERY: roll over images below to see larger image

Nylon Nailon™ Anchor (Mushroom)

Nylon Nailon™ Anchor (Round)

Zinc Nailon™ Anchor (Mushroom)


SPECIAL FEATURES

Nylon Nailon anchor: The nylon shell acts as an insulator when used In electrical applications.

Zinc Nailon anchor: Available with carbon and stainless-steel pins. The pin and head configuration make this anchor tamper resistant.

MATERIAL

Nylon Body: nylon – Pin – Cold-rolled steel
Zinc Body – die cast zinc alloy
Pin – Carbon and stainless steel (Type 304)

CODE REPORTS

Meets Federal Specification A-A-1925A, Type 1 (zinc mushroom).

INSTALLATION

See below.

 
 
Tension Load Normal Weight Concrete
Nylon Nailon™ Product Data and Tension Loads in Normal-Weight Concrete
Nylon Nailon Product Data and Tension Loads in Concrete

R = Round Head; M = Mushroom Head

  1. The allowable loads listed are based on a safety factor of 4.0.

 

 
Tension Load Shear Load Normal Weight Concrete
Zinc Nailon™ (Mushroom Head) Product Data and Tension and Shear Loads in Normal-Weight Concrete
Zinc Nailon Product Data and Tension and Shear Loads in Concrete
  1. The allowable loads listed are based on a safety factor of 4.0.
  2. Bulk Nailons come packed in a single carton of 1,000. To order add a "B" onto the end of the model number. Example: ZN25100B. Not available with stainless-steel pins.
 
INSTALLATION
go to top of page
 

cautionCaution: Oversized holes will make it difficult to set the anchor and will lower the anchor's load capacity.

caution
Not for use in overhead applications
caution
These anchors are not recommended for eccentric tension (prying) loading. Capacity can be greatly reduced in such applications.

 

 
  • Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified embedment depth plus 1/8" for pin extension and blow it clean using compressed air. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling.
  • Position fixture, insert Nailon anchor.
  • Tap with hammer until flush with fixture; drive pin until flush with top of head.
Installation Sequence
install sequence
 
 
 
go to top of page

Printed from
© 2014 Simpson Strong-Tie Company Inc.