Caution: Oversized holes will make it difficult to set the anchor and will reduce the anchor's load capacity.

• Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified embedment depth and blow it clean using compressed air. Overhead installations need not be blown clean. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling.
• Place the anchor in the fixture and drive into the hole until the washer and nut are tight against fixture.
• Tighten to required installation torque.

Sleeve-All Installation Data

1. Applies to Acorn and Hex head configurations only.

Sleeve-All® Installation Sequence