The PBV is a hidden standoff post base. Two different sizes fit a variety of posts shapes.

Material: 14 gauge galvanized steel

Finish: Textured powder-coated flat black paint or galvanized

Order: For powder coated finish, order PBV6PC or PBV10PC. For galvanized finish order PBV6 or PBV10. For kit containing SDS screws, RFB bolt, SET 1.7, and powder coated PBV, order PBV6KT or PBV10KT.

The CPS is a Composite Plastic Standoff designed for increased concrete surface area.

Material: Engineered composite plastic

Installation: PBV and CPS

• Post:
  • Drill a 3/4" diameter hole, 10" into the center of the post.
  • Clean out dust. Fill hole halfway with Simpson SET epoxy.
  • Insert all-thread rod and allow epoxy to set and cure.
  • Secure standoff to post using four 10d nails except PBV which uses four SDS screws.
• Concrete:
  • Drill a 3/4" diameter hole per anchor design (see footnote 2 below).
  • Clean out dust. Fill hole halfway with Simpson SET epoxy. Insert post subassembly into hole and allow epoxy to set and cure.
  • Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non top-supported installations (such as fences or unbraced carports).