×

We use cookies on this site to enhance your user experience. By clicking "I AGREE" below, you are giving your consent for us to set cookies. Privacy Policy

GH Top-Flange Girder Hanger

Girder Hangers/Beam Seats

This product's information may differ depending on the category of use. You are currently viewing details related to Girder Hangers/Beam Seats. You can also view product information related to the category: Top-Flange Masonry Hangers

A girder-to-foundation wall connection.

Material

  • 12 gauge

Finish

  • Simpson Strong-Tie gray paint; hot-dip galvanized: specify HDG. See Corrosion Information.

Installation

  • Use all specified fasteners; see General Notes.
  • Install four 0.162" x 3 1/2" nails into girder.
  • H = girder height – mudsill thickness. Measurement is from the bottom of the top flange to the top of the seat.
  • 1 1/2" clearance hole accommodates rebar or anchor. This is not required.

Options

  • GH hangers may be skewed to a maximum of 45°; bevel cut required. The allowable loads are 100% of the table load.
  • Specify GHD for saddle-style hangers. GHD may not be skewed.

Related Literature

Load Tables

    These products are available with additional corrosion protection. Additional products on this page may also be available with this option, check with Simpson Strong-Tie for details.

GH Girder Top-Flange Hanger Load Table
  1. Loads may not be increased for duration of load.
  2. A mudsill on top of the GH is required to achieve the table loads.
  3. Models listed are for a 2x plate; specify "H" dimension when ordering for use with a 3x plate.
  4. Uplift loads do not apply for this connector.
  5. Fasteners: Nail dimensions in the table are listed diameter by length. For additional information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.

Code Reports & Compliance

Drawings

PDF DWG DXF RFA IFC SAT