HTC Heavy Truss Clips

Typical HTC4 Installation on a 2x4 Plate

Typical HTC4 Installation on a 2x6 Plate

Allow 1/16" gap between nailhead and truss clip to help prevent squeaking. Nails should not be driven completely flush against the connector, to allow vertical truss movement.

www.strongtie.com

For alignment control between a roof truss and nonbearing walls; the 2 1/2" slot permits vertical truss chord movement when loads are applied.

Material: 18 gauge

Finish: Galvanized

Installation:

roll over images below to see larger image

Loads may not be increased for short-term loading.
Truss or rafter must be bearing on top plate to achieve the allowable loads under "WITHOUT GAP."
When installed with maximum 1 1/4" space between rafter or truss and top plate use loads under "WITH 1 1/4" GAP." Where loads are not required, space is not limited to 1 1/4".
NAILS: 10d = 0.148" dia. x 3" long. See other nail sizes and information.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
HTC	See specific model numbers for code listings.
HTC4	No code listing: Please contact us for test data.

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

topDrawings: To download drawings, right-click or Ctrl-click on the link, then choose "Save Target As..."

Download the Simpson Strong-Tie™ AutoCad® Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
HTC	None for this model	None for this model
HTC4	HTC4: DWG \| DXF HTC4 front view: DWG \| DXF HTC4 left view: DWG \| DXF HTC4 right view: DWG \| DXF HTC4 top view: DWG \| DXF	HTC4: DWG \| DXF