ITTM Engineered Wood Products Hangers

ITTM masonry-to-wood connectors can be directly embedded into a grouted block wall. It can also be installed on top of a masonry or concrete wall using Titen® screws.

Material: 12 gauge top flange and 18 gauge stirrup

Finish: Galvanized

Installation:

Use all specified fasteners.
ITTM installed into grouted block wall: embed into block with a minimum of one course of grouted block above and one course below the top flange. No Titen screws required.
ITTM installed on concrete masonry wall: install 1/4"x1 3/4" hex head Titen screws through preformed holes on the hanger.

Options: Options not available.

roll over images below to see larger image


Typical Mid-Wall ITTM Installed into Concrete Block (No Titens required) U.S. Patent 5,555,694		Typical Top-of-Wall ITTM Installed on a Grouted Block with Titens

ITTM Installation


Bend the tab with a hammer.	Hammer 10dx1 1/2 nail in at approximately 45°.	The tab is now correctly installed.

Uplift loads are based on DF/SP lumber and have been increased 60% for wind or earthquake loading with no further increase allowed. For normal loading applications such as cantilever construction refer to Simpson Strong-Tie® Connector Selector™ software or conservatively divide the uplift load by 1.6. For SPF use 0.86 x DF/SP uplift load.
Titen masonry screws are 1/4" x1 3/4".
Minimum f'_m = 1500 psi and f'_c = 2500 psi.
Mid-wall installation requires minimum of one grouted course above and below the hanger.
Products shall be installed such that the Titen screws are not exposed to the weather.
NAILS: 10dx1 1/2 = 0.148" dia. x 1 1/2" long. See other nail sizes and information.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
ITTM	See specific model numbers for code listings.
ITTM411.88	No code listing. Please contact us for test data.
ITTM414	No code listing. Please contact us for test data.
ITTM416	No code listing. Please contact us for test data.

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

Download the Simpson AutoCad Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
ITTM	None for this model	ITTM On Top of Block: DWG \| DXF ITTM In Grout Line: DWG \| DXF
ITTM411.88	None for this model	None for this model
ITTM414	None for this model	None for this model
ITTM416	None for this model	None for this model