×

We use cookies on this site to enhance your user experience. By clicking "I AGREE" below, you are giving your consent for us to set cookies. Privacy Policy

LSC Adjustable Stringer Connector

The LSC adjustable stair-stringer connector offers a versatile, concealed connection between the stair stringer and the carrying header or rim board while replacing costly framing. Field slopeable to all common stair stringer pitches, the LSC connector is suitable for either solid or notched stringers.

Key Features

  • Replaces additional framing and toe-nailing.
  • May be installed flush with the top of the carrying member (typically suitable for 2x10 or 2x12 header / rim board) or lower on the face (typically suitable for a 2x12 header / rim board).
  • Interchangeable for left or right applications.
  • LSCZ features a ZMAX® coating for additional corrosion protection. Suitable for interior and some exterior applications. LSCSS is made from stainless steel for higher exposure environments. See Corrosion Information.

Material

  • 18 gauge

Finish

  • LSCZ — ZMAX coating; LSCSS — stainless steel

Installation

  • Use all specified fasteners; see table.
  • Before fastening, position the stair stringer with the LSC on the carrying member to verify where the bend should be located.
  • The fastener that is installed into the bottom edge of the stringer must go into the second-to-last hole.
  • When installed on 1 5/16" LVL or a 1 1/4" LSL stringer, additional items that will not affect the structural performance of the LSC, but should be considered, include the following:
    — LSC stringer flange will protrude 1/4" from face of stringer. As such, it is recommended the LSC be installed with the tabs positioned to the outside of the stringer.
    — 1 1/2" fasteners installed into 1 1/4" LSL stringer will protrude from the opposite side.

Related Literature

Product Information Table

Fastener Production Information and Stuff & Things
Model No. Ga. Coating/Material Packaging Qty.
LSCSS 18 Stainless Steel 1
LSCZ 18 ZMAX® 1

Load Tables

    These products are available with additional corrosion protection.

    For stainless-steel fasteners, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.

    Many of these products are approved for installation with Strong-Drive® SD Connector screws.

LSC Adjustable Stringer Connector Load Table
  1. When installed on minimum 1 5/16" LVL or minimum 1 1/4" LSL stringers, allowable loads for DF/SP shall apply.
  2. When cross-grain bending or cross-grain tension cannot be avoided in the members, mechanical reinforcement to resist such forces shall be considered by the designer.
  3. #9 x 1 1/2" Strong-Drive® SD Connector screws may be substituted for 0.148" x 1 1/2" nails to achieve published nail values if the extra screw is installed in the narrow face of the stringer.
  4. When LSC is installed at end of rim board over support framing, use standard load.
  5. Fasteners: Nail dimensions in the table are diameter by length. SD screws are Simpson Strong-Tie® Strong-Drive SD Connector screws. For additional information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.

Code Reports & Compliance

Drawings

PDF DWG DXF RFA IFC SAT