LTHMA Multiple Truss Hangers

www.strongtie.com

Light capacity hanger designed to carry 2 or 3 trusses in a terminal hip installation. See also the MTHM/MTHM-2 hangers.

Material: 16 gauge.

Finish: Galvanized.

Installation:

Use all specified fasteners. See General Notes.
The total load must be symmetrically distributed about the centerline to avoid eccentric loading of the connector.
Fill round holes for girder trusses with 2x4 bottom chords.
Fill round and triangle holes for girder trusses with 2x6 bottom chords.

roll over images below to see larger image

Allowable loads have been increased 33% and 60% for earthquake or wind loading with no further increase allowed; reduce
where other loads govern.
Hip loads are for each hip.
Other hip/jack load distributions are allowed if the sum of all three carried members does not exceed the total load and the hip
members are equally loaded.
Load distribution is 45% for each hip and 10% for jack.
Truss chord cross-grain tension may limit allowable loads. Refer to Technical Bulletins: T-ANSITPISPF and T-ANSITPISP and T-ANSITPIDF for allowable loads that consider ANSI/TPI 1-2002 wood member design criteria.
NAILS: 10d = 0.148" dia. x 3" long, 10dx1 1/2 = 0.148" dia. x 1 1/2" long. See other nail sizes and information.