STC/STCT/DTC Roof Truss Clips

Typical STC Installation with DS

Nails should not be driven completely flush against the connector, to allow vertical truss movement.

www.strongtie.com

Installation

View step-by-step installation instructions

For alignment control between a roof truss and nonbearing walls; the 1 1/2" slot permits vertical truss chord movement when loads are applied.

Material: 18 gauge.

Finish: Galvanized.

Installation:

Use all specified fasteners; see General Notes.
Use STC or DTC depending on required loads. STC, installed with Drywall Stop (DS), helps prevent fasteners tearing through the ceiling sheetrock (see illustration).
Use STCT where truss or rafter is separated from the top plate of the nonbearing wall.
Install slot nails in the middle of the slot.

roll over images below to see larger image

Loads may not be increased for short-term loading.
Truss or rafter must be bearing on top plate to achieve the allowable loads under "WITHOUT GAP."
Clips are required on both sides of the truss to achieve F₁ loads in both directions (stagger parts to avoid nail interferences).
Nails: 8d = 0.131" dia. x 2 1/2" long. See other nail sizes and information.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
DTC	No code listing: Please contact us for test data.
STC	No code listing: Please contact us for test data.
STCT	No code listing: Please contact us for test data.

topDrawings: To download drawings, right-click or Ctrl-click on the link, then choose "Save Target As..."

Download the Simpson AutoCad Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
DTC	DTC: DWG \| DXF DTC front view: DWG \| DXF DTC right view: DWG \| DXF DTC top view: DWG \| DXF	None for this model
STC	STC: DWG \| DXF STC front view: DWG \| DXF STC right view: DWG \| DXF STC top view: DWG \| DXF	STC: DWG \| DXF
STCT	STCT: DWG \| DXF STCT front view: DWG \| DXF STCT right view: DWG \| DXF STCT top view: DWG \| DXF	None for this model