TC Truss Connectors

TC24
U.S. Patent 4,932,173

TC26
(TC28 similar)

Typical TC24 Installation

Optional TC26 Installation for Grouted Concrete Block using a Wood Nailer
(8", 10", 12" Wall Installation similar)

Optional TC26 Installation for Grouted Concrete Block using Titen^® Screws

The TC truss connector is an ideal connector for scissor trusses and can allow horizontal movement up to 1 1/4". The TC also attaches plated trusses to top plates or sill plates to resist uplift forces. Typically used on one or both ends of truss as determined by the Designer.

Material: 16 gauge

Finish: Galvanized

Installation:

Use all specified fasteners. See General Notes.
Drive 10d nails into the truss at the inside end of the slotted holes (inside end is towards the center of the truss). Do not seat these nails into the truss - allow room under the nail head for movement of the truss with respect to the wall.
After installation of roofing materials nails may be required to be fully seated into the truss. (As required by the Designer or Truss Designer.)

Optional TC Installation

Bend one flange up 90°. Drive specified nails into the top and face of the top plates or install Titen^® screws into the top and face of masonry wall. See optional load tables and installation details.

roll over images below to see larger image

Loads have been increased 60% for wind or earthquake loading; no further increase allowed; reduce where other loads govern.
Grout strength is 2000 psi minimum.
Nail values based on single 2x truss.
Optional TC26 installation with 10d nails requires minimum 3" top plate thickness.
NAILS: 10d = 0.148" dia. x 3" long, 10dx1 1/2" = 0.148" dia. x 1 1/2 " long. See other nail sizes and information.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
TC	See specific model numbers for code listings.
TC24	No code listing: Please contact us for test data.
TC26		ESR-2605 / ESR-2523 *		FL10861
TC28		ESR-2605 / ESR-2523 *		FL10861

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

Download the Simpson AutoCad Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
TC	None for this model	TC View 1: DWG \| DXF TC View 3: DWG \| DXF TC View 2: DWG \| DXF
TC24	TC24: DWG \| DXF TC24 front view: DWG \| DXF TC24 left view: DWG \| DXF TC24 right view: DWG \| DXF TC24 top view: DWG \| DXF	None for this model
TC26	TC26: DWG \| DXF TC26 front view: DWG \| DXF TC26 left view: DWG \| DXF TC26 right view: DWG \| DXF	None for this model
TC28	TC28: DWG \| DXF TC28 front view: DWG \| DXF TC28 left view: DWG \| DXF TC28 right view: DWG \| DXF	None for this model