• Load Table
• Gallery of images
• Code Reports
• Drawings
• Catalog Page
• Related Categories
• Technical Bulletins
• Fliers
• Help for downloads

The THA series have extra long straps that can be field-formed to give height adjustability and top flange hanger convenience. THA hangers can be installed as top flange or face mount hangers.

THA4x and THA2x-2 models feature a dense nail pattern in the straps, which provides more installation options and allows for easy top flange installation.

Material: See table.

Finish: Galvanized, some products available in ZMAX® coating. See Corrosion Information.

Installation:

• Use all specified fasteners. See General Notes.

The following installation methods may be used:

• Top Flange Installation—The straps must be field formed over the header - see table for minimum top flange requirements. Install top and face nails according to the table. Top nails shall not be within 1/4" from the edge of the top flange members. For the THA29, nails used for joist attachment must be driven at an angle so that they penetrate through the corner of the joist and into the header. For all other top flange installations, straighten the double shear nailing tabs and install the nails straight into the joist.
• Face Mount Installation—Install all face nails according to the table. Not all nail holes will be filled on all models. On models where there are more nail holes than required, the lowest 4 face holes must be filled. Nails used for the joist attachment must be driven at an angle so that they penetrate through the corner of the joist into the header.
• Alternate Installation—The THA 4x hangers may be installed in a top flange configuration using the tabulated fasteners for face mount installation and achieve the face mount installation loads. Install the tabulated face nails into the face and top of the carrying member. Nails used for the joist attachment must be driven at an angle so that they penetrate through the corner of the joist into the header.
• Uplift—Lowest face nails must be filled to achieve uplift loads.

Options:

• THA hangers available with the header flanges turned in for 3 5/8" (except THA413) and larger, with no load reduction - order THAC hanger.