UFP Universal Foundation Plate

www.strongtie.com

>>Home > All Products - Alphabetical List

The UFP provides a retrofit method to anchor the mudsill to the side of the foundation in applications where minimum vertical clearance exists. The UFP is also designed to perform when the mudsill is offset from the foundation up to 2 1/2" or extended beyond the foundation up to 1/2".

The UFP may be used in place of the FA, HFA and FAP connectors.

Material: 14 gauge.

Finish: Galvanized. May be ordered HDG, contact Simpson. See Corrosion Information.

Installation:

Use all specified fasteners; see General Notes.
Loads are based on test results using Simpson's SDS 1/4"x3" screws, which are supplied with the UFP10.
Alternate lag screws will not achieve published loads.
Refer to technical bulletin T-ANCHORSPEC for post-installed anchorage solutions.

top Gallery:

roll over images below to see larger image


UFP10 installed on a Straight Foundation with 1/2" Offset Mudsill U.S. Patent 5,732,519	UFP10 installed on a Straight Foundation	UFP10 installed on a Trapezoid Foundation

top Load Table:See code report listings below

Allowable loads have been increased 33% for earthquake or wind loading, with no further increase allowed. Reduce where other load durations apply.
Each anchor bolt requires a standard cut washer.

top Code Reports (PDFs):

					Legacy Reports
	IAPMO ES	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
UFP	See specific model numbers for code listings.
UFP10	No code listing. Please contact us for test data.
UFP10-SDS3		ESR-2616	RR25281			ER-5313