text.skipToContent text.skipToNavigation

DJT Deck Joist Tie

DJT

On This Page

The DJT14Z deck joist tie is designed to attach 2x deck joists to the side of 4x or larger support posts. The DJT14Z can be installed with either nails or bolts.

Material

  • 14 gauge

Finish

  • ZMAX® coating; see Corrosion Information

Installation

  • Use specified HDG fasteners; see General Notes
  • Recommended: install on post first
  • Minimum 2x4 joist and 4x4 post

Related Literature

Load Tables

Load Values with Nails

    These products are available with additional corrosion protection. Additional products on this page may also be available with this option, check with Simpson Strong-Tie for details.

    For stainless-steel fasteners, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.

    Many of these products are approved for installation with Strong-Drive® SD Connector screws.

DJT14Z Deck Joist Tie Load Table
  1. Loads are for one DJT14Z.
  2. Roof loads are 125% of floor loads unless limited by other criteria. Floor loads may be adjusted for load durations according to the code provided they do not exceed those in the roof column.
  3. Install bolts or nails as specified by Designer. Bolt and nail values may not be combined.
  4. Fasteners: Nail dimensions in the table are listed diameter by length. For additional information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.
Load Values with Strong-Drive® SD Connector Screws
Model No. Fasteners Allowable Loads
Floor (100) Roof (125)

    These products are available with additional corrosion protection. Additional products on this page may also be available with this option, check with Simpson Strong-Tie for details.

DJT14Z 8-SD10212 1250 1490

Code Reports & Compliance

Drawings

PDF DWG DXF RFA IFC SAT