ET-HP is a two-component, high-solids, epoxy-based system for use as a high-strength, non-shrink anchor-grouting material. Resin and hardener are dispensed and mixed simultaneously through the static mixing nozzle. ET-HP is formulated for anchoring threaded rod and rebar into concrete (cracked/uncracked) and masonry.
|Model No.||Option||Packaging Qty.||Carton Qty.||Compatible Tools|
|ET-HP22||22 oz. side-by-side cartridge||1||10||EDT22S, EDTA22P, EDTA22CKT dispensing tools / EMN22i mixing nozzle|
|ET-HP22-N||22 oz. side-by-side cartridge w/ EMN22i mixing nozzle||1||10||EDT22S, EDTA22P, EDTA22CKT dispensing tools|
|ETHP100KT||100 gallon kit (23,100 oz.) / (2) 50-gallon pails||1||–||Metering pumps offered by third-party manufacturers / EMN37A|
|ETHP10KT||10-gallon kit (2,310 oz.) / (2) 5-gallon pails||1||–||Metering pumps offered by third-party manufacturers / EMN37A|
|ETHP1KT||1 gallon kit (231 oz.) / (2) 1/2-gallon pails||1||1||Metering pumps offered by third-party manufacturers / EMN37A|
Anchors installed with ET-HP adhesive have been tested in accordance with ICC-ES Acceptance Criteria for Post-Installed Adhesive Anchors in Masonry Elements (AC58) and Adhesive Anchors in Concrete Elements (AC308).
|*Material and curing conditions: 73 ± 2˚F, unless otherwise noted.|
|Consistency||ASTM C881||Non-sag/thixotropic paste|
|Heat deflection||ASTM D648||145°F (63°C)|
|Glass transition temperature||ASTM D648||168°F (76°C)|
|Bond strength (moist cure, 60°F)||ASTM C882||2,963 psi (2 days) |
3,002 psi (14 days)
|Water absorption||ASTM D570||0.0% (24 hours)|
|Compressive yield strength (cured 60°F)||ASTM D695||14,260 psi (7 days)|
|Compressive modulus||ASTM D695||775,850 psi (7 days)|
|Gel time||ASTM C881||10 minutes|
|Shore D Durometer||ASTM D2240||87|
|Volatile Organic Compound (VOC)||—||3 g/L|
Anchoring adhesive shall be a two-component high solids epoxy based system supplied in manufacturer's standard side-by-side cartridge and dispensed through a static-mixing nozzle supplied by the manufacturer. Epoxy shall meet the minimum requirements of ASTM C-881 specification for Type I, II, IV, and V, Grade 3, Class B and C, except gel time, and must develop a minimum 13,390 psi compressive yield strength after 7 day cure. Epoxy must have a heat deflection temperature of a minimum 168°F (76°C). Adhesive shall be ET-HP adhesive from Simpson Strong-Tie, Pleasanton, CA. Anchors shall be installed per Simpson Strong-Tie instructions for ET-HP adhesive.