text.skipToContent text.skipToNavigation

Steel Strong-Wall® Anchor Bolt Templates 

Steel Strong-Wall® Anchor Bolt Templates

Lateral Systems

This product's information may differ depending on the category of use. You are currently viewing details related to Lateral Systems. You can also view product information related to the category: Steel Strong-Wall® Templates

Simpson Strong-Tie now offers anchor bolt stabilizers that may be used with all anchor template models. The bolt stabilizer enables the steel Strong-Wall anchorage to be installed without being tied to the footing rebar cage by helping to eliminate movement of the anchor bolts during concrete placement. Two bolt stabilizers are used for each SSW anchor assembly; one at the embedded plate washer and the other above the template. Half-inch-diameter dowels (not supplied) are then driven down through the bolt stabilizers and into the ground to ensure plumb installation of the anchors and prevent movement during concrete placement. Immediately following concrete placement, the dowels are removed and reused in other locations.

Installation

  • Installation of Steel Strong-Wall templates varies by application. See page 35 in C-L-SW17 for details.

Related Literature

Product Information Tables

Steel
Strong-Wall
Model
Width (in.) Anchor Bolt
Stabilizer Model
Steel Strong-Wall Template Model
Reversible Panel Form Brick Ledge Extended Leg
S/SSW12 12 SSWBS12 SSWT12 SSWTPF12 SSWTBL12 SSWTEL12
S/SSW15 15 SSWBS15 SSWT15 SSWTPF15 SSWTBL15 SSWTEL15
S/SSW18 18 SSWBS18 SSWT18 SSWTPF18 SSWTBL18 SSWTEL18
S/SSW21 21 SSWBS21 SSWT21 SSWTPF21 SSWTBL21 SSWTEL21
S/SSW24 24 SSWBS24 SSWT24 SSWTPF24 SSWTBL24 SSWTEL24
  1. The height of the garage curb above the garage slab is critical for rough header opening at garage return walls.
  2. Templates are recommended and are required in some jurisdictions.
  3. Foundation design by Designer.
  4. Reversible, panel form and bridge ledge templates are the same for 4" or 6" thick walls.