The Titen HD® threaded rod hanger is a high-strength screw anchor designed to suspend threaded rod from concrete slabs and beams or concrete over metal in order to hang pipes, cable trays and HVAC equipment. The anchor offers low installation torque with no secondary setting, and has been tested to offer industry-leading performance in cracked and uncracked concrete – even in seismic loading conditions.
Thread design undercuts to efficiently transfer the load to the base material
Serrated cutting teeth and patented thread design enable quick and easy installation
Specialized heat-treating process creates tip hardness to facilitate cutting while the anchor body remains ductile
Designed to install using a rotary hammer or hammer drill with standard ANSI drill bits – no special tools required
Installs with standard-sized sockets
The THD50234RH and THD37212RH are code listed for cracked and uncracked concrete applications under the 2012 and 2009 IBC/IRC, per ICC-ES ESR-2713
Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 1/2" deeper than the required embedment.
Blow the hole clean of dust and debris using compressed air.
IMPORTANT: Install with an applied torque of 15 ft-lbs for the THD25112RH and THD37218RH rod hangers using a torque wrench, driver drill, hammer drill or cordless 1/4" impact driver with a maximum permitted torque rating of 100 ft-lb.
Oversized holes in the base material will reduce or eliminate the mechanical interlock of the threads with base material and will reduce the anchor’s load capacity.
Use a Titen HD® Rod Hanger one time only. Installing the anchor multiple times may result in excessive thread wear and reduce load capacity.