Self-Drilling E Metal Screw
On This Page
Product Details
Key Features
- Hex-washer head
- Clear zinc finish
- Recommended for use with certain Simpson Strong-Tie® connectors
- #3 drill point (max. total drilling thickness 0.35")
- Bit included in each box (replacement driver bit — BITHEXR38-134)
Applications
- Cold-formed steel framing
Related Links
Catalog Pages
- Fastener Product Information: C-F-2019, page 93
- Fastener Technical Data and Loads: C-F-2019TECHSUP, page 157
Related Literature
Product Information Table
| Model No. | Coating/Material | Screw Size | Length (in.) | Head Diameter (in.) | Drive Type | Head Type | TPI | Point Type | Point Size | Packaging Qty. | UPC |
|---|---|---|---|---|---|---|---|---|---|---|---|
| E1B1414B | Clear Zinc Coating | #14 | 1 | 0.500 | 3/8 in. Hex | Hex Washer Head | 14 | Drill Point | 3 | 2500 | 746056101604 |
| E1B1414R100 | Clear Zinc Coating | #14 | 1 | 0.500 | 3/8 in. Hex | Hex Washer Head | 14 | Drill Point | 3 | 100 | 746056119401 |
Product Information Table
| Model No. | Length (in.) | Screw Size | Drive Type | Head Diameter (in.) | Head Type | TPI | Point Size | Point Type | Coating/Material | Packaging Quantity | UPC |
|---|---|---|---|---|---|---|---|---|---|---|---|
| E1B1414B | 1 | #14 | 3/8 in. Hex | 0.500 | Hex Washer Head | 14 | 3 | Drill Point | Clear-Zinc Coating | 2500 | 746056101604 |
| E1B1414R100 | 1 | #14 | 3/8 in. Hex | 0.500 | Hex Washer Head | 14 | 3 | Drill Point | Clear-Zinc Coating | 100 | 746056119401 |
Load Tables
Screw Strength
Screw-to-Cold-Formed Steel Member Connection Loads, Steel to Steel
- Screws shall extend through the connection with a minimum of three exposed threads per AISI General Provisions Standard Section D1.3.
- Tabulated loads are based on calculations per AISI S100 using the thinner steel member in the connection. A safety factor of Ω = 3.0 and resistance factor Φ = 0.5 were used to determine the ASD and LRFD strength values.
- Loads are based on cold-formed steel members with a minimum yield strength, Fy, of 33 ksi and tensile strength, Fu, of 45 ksi for 43 mil (18 ga.) and thinner, and a minimum yield strength of 50 ksi and tensile strength of 65 ksi for 54 mil (16 ga.) and thicker.
Code Reports & Compliance
Drawings
| DWG | DXF | RFA | IFC | SAT | |||
|---|---|---|---|---|---|---|---|
