×

We use cookies on this site to enhance your user experience. By clicking "I AGREE" below, you are giving your consent for us to set cookies. Privacy Policy

MBHA Concrete and Masonry Top-Flange Hanger

The MBHA is a single piece, non-welded connector available for solid sawn, truss and engineered wood products.

Material

  • 10 gauge

Finish

  • Galvanized

Installation

  • Use all specified fasteners; see General Notes

Options

  • Seat can be skewed at 45° only. The maximum allowable download is 3,495 lb. and 1,585 lb. uplift for height 7 1/4". For all other models, use the table listed download and uplift of 2,390 lb. Order MBHAR for skew right and MBHAL for skew left.

Related Literature

Product Information Tables

MBHA Product Table

Load Tables

MBHA Load Table
  1. ATR is all-thread rod, grade A307 or better.
  2. Concrete shall have a minimum compressive strength of f'c = 2,500 psi.
  3. Grout-filled CMU (GFCMU) shall have a minimum compressive strength of f'm = 1,500 psi.
  4. Uplift loads have been increased for earthquake or wind loading with no further increase allowed. Reduce where other loads govern.
  5. Loads are based on installation using SET-3G™ or SET-XP® adhesive with 6 3/4" minimum embedment required. Refer to the Simpson Strong-Tie® Anchoring, Fastening and Restoration Systems for Concrete and Masonry catalog.
  6. MBHA hangers with height of 7 1/4" require a 3 1/2" minimum embedment of the face bolt using SET-3G adhesive.
  7. Alternative anchorage to be designed by others.
  8. Table allowable loads were determined using the tested ultimate load with a safety factor of three or fastener calculation values.
  9. Fasteners: Nail dimensions in the table are listed diameter by length. For additional information, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors.

Code Reports & Compliance

Drawings

PDF DWG DXF RFA IFC SAT